Plenty of fluorescent fixtures still turn on. But "still works" isn't the same as "still worth it." If a few of these signs sound familiar, it's time to move those fixtures to LED tubes, or replace them outright.
1. The ballast hums or buzzes
Fluorescent tubes need a ballast to start and run, and older magnetic ballasts can develop an audible hum. With double-ended (ballast bypass) LED tubes, the ballast comes out for good: nothing left to hum, nothing to replace.
2. Slow, dim starts in the cold
In an unheated garage, barn or cooler, fluorescents can start slow and dim. The U.S. Department of Energy lists good cold-temperature performance and instant-on among LED's strengths.
3. Flicker, cycling or blackened ends
Tubes that flicker, blink on and off by themselves or darken near the ends are wearing out. Another fluorescent tube just resets the clock. (Seeing flicker after switching to LED? See why new LED tubes flicker in an old fixture.)
4. You're always back on the ladder
Fluorescent life drops the more often the lights are switched on and off, so storage rooms and motion-sensor spots burn through tubes. Per DOE, switching doesn't shorten LED life.
5. Light goes everywhere but down
Fluorescent tubes shine in all directions, and DOE notes much of that light is lost inside the fixture. LEDs are directional. Orilis double-ended LED T8 tubes are 22W, about 3,000 lumens each, in 4500K, 5000K or 6500K.
6. Mercury makes every dead tube a chore
Fluorescent tubes contain mercury, and the EPA recommends recycling them (local rules vary). LED tubes contain no mercury.
7. Replacement tubes are getting harder to find
Several states have ended sales of most linear fluorescent tubes, and an international agreement phases out their manufacture for general lighting by 2027. Florida has no ban yet, but supply follows the market. Details: the fluorescent phase-out, explained.
Two easy ways out
- Fixture in good shape? Convert it. The Orilis 4-light retrofit kit has four 22W double-ended tubes, eight non-shunted lamp holders, wires and wire nuts for one 4-lamp or two 2-lamp fixtures. Walkthrough: convert a 4 ft fluorescent fixture to LED.
- Rusted, cracked, damp or dusty? Replace it. Orilis vapor tight LED fixtures are sealed, IP65-rated, in 2 ft (36W, 3,600 lumens) and 4 ft (72W, 8,000 lumens), each in 4500K or 6500K.
Orilis sells double-ended tubes only. Here's single-ended vs double-ended and ballast bypass vs plug-and-play.
Safety first: turn the power off at the breaker and confirm with a voltage tester before opening any fixture. Wire Line on one end and Neutral on the other with non-shunted sockets, and label converted fixtures. If you're not comfortable with line-voltage work, have a qualified, licensed electrician do the ballast bypass.
Ready to retire the fluorescents?
Shop double-ended LED tubes, the retrofit kit or vapor tight fixtures at orilis.com, email info@orilis.com or call 1-407-900-9745.
